One channel relay voltage problem

Got something to discuss that's not about Blackmagic products? Then check out the Off-Topic forum!
  • Author
  • Message
Offline

robinsenny

  • Posts: 1
  • Joined: Tue Jul 24, 2018 6:59 am
  • Real Name: robinsenny

One channel relay voltage problem

PostThu Jul 26, 2018 1:58 pm

Hi,

I have a problem with relay serve. I've used simple code on python for switching GPIO output 0/1 but the relay do only one operation - close and doesn't switch back. The relay is connected to 5V = VCC, Ground = GND and GPIO 23 = INN. When i messure the voltage on VCC and INN on startup its about 0.6volts. When i run the script and setup the pin and make the output LOW(relay ON) the voltage goes to 4,75 volt and the relay is turning on but when i set te output to HIGH(relay OFF) nothing happend and the voltage is about 1.5v volt. When i switch the board to 3.3v everything worked fine but its 5v relay why do i have to connect it to 3.3v to get it working? Can someone help me out ?
Offline
User avatar

Xtreemtec

  • Posts: 5391
  • Joined: Wed Jan 02, 2013 11:48 am
  • Location: The Netherlands

Re: One channel relay voltage problem

PostThu Jul 26, 2018 4:42 pm

What product are you talking about????? :?
Code on python? Relays? Switched the board power from 3.3 to 5V?

I can not make any relation to what product we are talking about...
Daniel Wittenaar .:: Xtreemtec Media Productions ::. -= www.xtreemtec.nl =-
4K OBV Trailer, ATEM TVS HD, 4M/E Broadcast Studio 4K, Constelation 8K, Hyperdeck Studio 12G, Ursa Broadcast 4K, 4K fiber converters with Sony Control

Return to Off-Topic

Who is online

Users browsing this forum: No registered users and 24 guests