Blackmagic Forum

I've managed to damage my UM4.6k PL beyond repair (BMD's assessment is it's too expensive to repair, and is cheaper to replace).

However, the camera is mostly is good condition. It still turns on and functions to some extent. I've stripped it down and it actual looks to be relatively simple to change parts on. Well, just whole parts (entire PCB etc). I'm looking for another UM4.6k that may not be working, to then swop out parts to see if I can get a single working camera. More an experiment than a scientific technical endeavour.

Got a dead one lying around and you're not quite sure what to do with it?

Hello, I have a URSA Mini 4.6k for sale. Let me know if you're still in the market

Keep in Mind that there has been Some calibration of the sensor stored in the fpga. So it is better to keep the sensor and fpga as a pair. Otherwise you could end up with strange discoloration, pattern or other funky video errors.

Hbyrne wrote:Hello, I have a URSA Mini 4.6k for sale. Let me know if you're still in the market

Hi. Still for sale? Where are you based? I'm in Australia.

What went wrong with yours?