- Posts: 5
- Joined: Wed Dec 05, 2012 9:52 pm
Wed Dec 05, 2012 10:15 pm
Re: UltraScope could not configure the capture hardware
I keep getting this same error trying to launch ultrascope via a Tenarax 2d and wondering if my GUi is suitable.
trying to use on a mac powerbook 15" (1220x880) 2.3ghz
here are the specs for the GUI.
AMD Radeon HD 6750M:
Chipset Model: AMD Radeon HD 6750M
Type: GPU
Bus: PCIe
PCIe Lane Width: x8
VRAM (Total): 512 MB
Vendor: ATI (0x1002)
Device ID: 0x6741
Revision ID: 0x0000
ROM Revision: 113-C0170L-573
gMux Version: 1.9.23
EFI Driver Version: 01.00.573
suggestions? ideas?
thanks !!!
I keep getting this same error trying to launch ultrascope via a Tenarax 2d and wondering if my GUi is suitable.
trying to use on a mac powerbook 15" (1220x880) 2.3ghz
here are the specs for the GUI.
AMD Radeon HD 6750M:
Chipset Model: AMD Radeon HD 6750M
Type: GPU
Bus: PCIe
PCIe Lane Width: x8
VRAM (Total): 512 MB
Vendor: ATI (0x1002)
Device ID: 0x6741
Revision ID: 0x0000
ROM Revision: 113-C0170L-573
gMux Version: 1.9.23
EFI Driver Version: 01.00.573
suggestions? ideas?
thanks !!!