Fri Mar 24, 2017 4:40 am
Hey
I have a Flysky FS-i6 which is basically a 6 channel radio control transmitter and receiver using PWM to control servos and it also has switches...
I am trying to get the BMMCC to start/stop by assigned Channel 6 to one of the on/off switches and then in the BMMCC assigning SERVO1 to Rec/stop and then plugging the servo1 cable to the correct channel on the receiver.. Red being ground and white being the signal...
It doesn't work!!
Well it did once but doesn't stop when I switched it off....
Is this possible?
It's supposed to work right?
Is there anything else I need to know or do?
Cheers
Mat
Mathew Hamilton Green
Writer, Director, Editor
BMPCC4K, BMPCC & BMMCC
Apple Mac Mini M1 - 16GB
Alienware 17 r5
Intel Core i7-8750H 6 Core
32GB RAM
nVidia GeForce GTX 1070 8Gb