Digital Monitor Recording in RTSP or Analog BNC/Component

Getting started with a Blackmagic product? Ask questions here about setup and installation.
  • Author
  • Message
Offline

Dale Wuttke

  • Posts: 2
  • Joined: Mon Oct 16, 2017 10:30 pm

Digital Monitor Recording in RTSP or Analog BNC/Component

PostMon Oct 16, 2017 11:02 pm

I have an application where I need to record the monitor streams from 7 operators 2 primary display monitors(14 streams total).

The computers are running a standard windows 10 platform and the video is coming from a Nvidia Quadro graphics card. I could change up the graphics cards but would rather leave it as is due to the software compatibility work best with a Quadro CUDA card.

I have the ability to split the HDMI/DVI feed into an encoder and take the output in the form of an RTSP stream or preferably an Analog composite/BNC output. Even better would be a feedthrough HDMI in/out so I don't have to use an HDMI splitter.

The video will be stored in an IP surveillance video management system.

Historically I have been using an Epiphan DVI broadcaster, these have worked great but the cost has been an issue for my clients.

Very important is the 100% uptime with 100% duty cycle, these machines operate 24/7 in a mission critical operation.

Any advice would be greatly appreciated!

Regards,
Dale
Offline
User avatar

Xtreemtec

  • Posts: 1586
  • Joined: Wed Jan 02, 2013 11:48 am
  • Location: The Netherlands

Re: Digital Monitor Recording in RTSP or Analog BNC/Componen

PostTue Oct 17, 2017 11:23 am

Can you change the IP Survailance for a SDI DVR??
If so you could put Decimator MD-HX or even LX between them. HDMI in and trough output. With extra SDI output. Then run these SDI outputs to a SDI DVR. (Which can also been monitored ands played back by IP in a browser... )

I think this could be a cost effective solution. ;)
Daniel Wittenaar .:: Xtreemtec Media Productions ::. -= www.xtreemtec.nl =-
4K OBV, ATEM TVS HD, Production Studio 4K, 2M/E Broadcast Studio 4K, Hyperdeck Studio, SONY FS7 4K, JVC HM700 Full HD Camera
Offline

Dale Wuttke

  • Posts: 2
  • Joined: Mon Oct 16, 2017 10:30 pm

Re: Digital Monitor Recording in RTSP or Analog BNC/Componen

PostThu Oct 19, 2017 7:57 pm

Hello,
Thank you for the recommendations but I am restricted to the Avigilon VMS for video recording. With this platform I can only support IP or analog through IP encoders that do not support SDI just standard "composite Video 1.0 Vpp with 75 Ohm selectable termination".

Return to Getting Started

Who is online

Users browsing this forum: No registered users and 7 guests