Page 1 of 1

Powering Video Assist 4K via D-tap cable

PostPosted: Tue Jan 02, 2018 1:18 pm
by Terje Rian
Hi,

I just got hold of the Lanparte D-Tap to DC Barrel Power Cable, which allows you to power your 2.5K or 4K Blackmagic Camera directly from a D-Tap-equipped power source. Can anyone confirm that they use this particular cable with their Video Assist 4K monitor/recorder without modification to the cable - or - if the Blackmagic Cameras are “interchangeable” with (or similar to) the Video Assist 4K when it comes to the use of external power sources?

Thank you!

Best,
Terje Rian

Re: Powering Video Assist 4K via D-tap cable

PostPosted: Tue Jan 02, 2018 5:02 pm
by Xtreemtec
Yes you can, While the VA 4k says 12V on the body. The power regulator will accept up to 17Volts.

Re: Powering Video Assist 4K via D-tap cable

PostPosted: Thu Mar 08, 2018 5:30 pm
by Terje Rian
Thank you for your kind help. Sorry for the delay. I wasn't aware of your reply until now. The forum notification might be off or something.

Best,
Terje Rian