SDI to HDMI Miniconverter 6G connects 2 screen message comes

Getting started with a Blackmagic product? Ask questions here about setup and installation.
  • Author
  • Message
Offline

alexm2day@gmail.com

  • Posts: 1
  • Joined: Mon Apr 23, 2018 5:08 pm
  • Real Name: Alexander Mekhonoshin

SDI to HDMI Miniconverter 6G connects 2 screen message comes

PostMon Apr 23, 2018 5:28 pm

SDI cable coming from switched on BMCC 2,5K and connected to a Miniconverter SDI IN, HDMI cable at its turn is connected to HDMI OUT on converter from one end, and to HDMI IN of the screen at the other end. Screen specs are: FullHD 1920 x 1080. Software installed to the PC, as well as drivers.
But below message appears on screen and does not go off:

"Input Signal Out of Range

Current Mode:
H= 28.6 kHz, V= 50Hz

Change Mode to:
1920 x 1080 60 Hz"

Apart from this, after all, when HDMI cable is disconnected from the screen, screen Switch off is locked. And its impossible to switch off the screen. Switch off of the screen is locked.

Please advise on the solution.
Offline

Byron Bonifassi

Blackmagic Design

  • Posts: 10
  • Joined: Fri Jun 17, 2016 12:27 am

Re: SDI to HDMI Miniconverter 6G connects 2 screen message c

PostFri Apr 27, 2018 12:31 am

"Signal out of range" usually means that the monitor does not support the signal that you are feeding it. This camera supports the frame rates below, so verify if your monitor supports the following.

1080p - 23.98, 24, 25, 29.97, 30.
Blackmagic Technical Support (US)
support-usa@blackmagicdesign.com

Return to Getting Started

Who is online

Users browsing this forum: No registered users and 35 guests