DeckLink SDI Micro unable to capture/playback after reboot

Getting started with a Blackmagic product? Ask questions here about setup and installation.
  • Author
  • Message
Offline

masumkdr

  • Posts: 2
  • Joined: Mon Jan 21, 2019 2:34 pm
  • Real Name: Masum Khandker

DeckLink SDI Micro unable to capture/playback after reboot

PostMon Jan 21, 2019 2:51 pm

Hello All,

I am using DeckLink SDI Micro with Intel NUC for capturing and playback. Its working very good.

But after soft reboot of my NUC its not capturing/playback. I must need to shutdown the pc for few moment and then if i run again its working. Followign is my platform.

1. DeckLink SDI Micro
2. INTEL NUC
3. Fedora 29 64 bit
4. ffmpeg software


After reboot decklink card detected, i can see the detected card in gui. But i can make any capture/playback until power off the and start it again.



Please help me If there are any solution.

Thanks
Masum
Offline

masumkdr

  • Posts: 2
  • Joined: Mon Jan 21, 2019 2:34 pm
  • Real Name: Masum Khandker

Re: DeckLink SDI Micro unable to capture/playback after rebo

PostSun Feb 03, 2019 7:53 am

I have solved it with latest Blackmagic linux driver that is 10.11.4.


Thanks

Return to Getting Started

Who is online

Users browsing this forum: No registered users and 6 guests