Blackmagic Forum

Hello All,

I am using DeckLink SDI Micro with Intel NUC for capturing and playback. Its working very good.

But after soft reboot of my NUC its not capturing/playback. I must need to shutdown the pc for few moment and then if i run again its working. Followign is my platform.

1. DeckLink SDI Micro
2. INTEL NUC
3. Fedora 29 64 bit
4. ffmpeg software


After reboot decklink card detected, i can see the detected card in gui. But i can make any capture/playback until power off the and start it again.



Please help me If there are any solution.

Thanks
Masum

I have solved it with latest Blackmagic linux driver that is 10.11.4.


Thanks