Videohub Hardware Panel Setup
Posted: Tue Feb 19, 2019 3:46 am
Where is the best place to go to make suggestions for software improvement where Blackmagic Design can see it and respond? The videohub panel software needs some work:
1. Ability to copy and paste macros to speed up the setup
2. Ability to activate macros over the network
3. An Auto discovery tool to find panel on the network
4. A better way to map macros using names pulled from a smarthub instead of just port numbers
5. Allowing the program to change height/width depending on the computer monitor's resolution or at least give the user a chance to rescale the program.
Any chance we could see any of these ideas implemented in the next version of the software?
1. Ability to copy and paste macros to speed up the setup
2. Ability to activate macros over the network
3. An Auto discovery tool to find panel on the network
4. A better way to map macros using names pulled from a smarthub instead of just port numbers
5. Allowing the program to change height/width depending on the computer monitor's resolution or at least give the user a chance to rescale the program.
Any chance we could see any of these ideas implemented in the next version of the software?