Mini Pro : can't calibrate sensor

Hello

just got my new ursa mini pro and wanted to calibrate the sensor
but the camera tells me that too much light is hitting the sensor and I can't calibrate,
even though I put the cap on, am in a dark room...

any ideas ?
thanks

Have you shot a little footage with the lens cap on to see if you can notice some light leaks?

Try removing the lens and putting the camera body cap on instead. That was the original way to do it. If it still says you have too much light, then something is wrong with the camera. It’s not you. I’d call BMD Support.


Sent from my iPhone using Tapatalk

I did test it with the camera body cap !
same message

Sounds like a fault then.

My UMP did this a few weeks ago. Same scenario, lens cap on and got the too much light message.I did a camera factory reset and I was able to calibrate the sensor from there and haven't had the issue happen again..

My UMP did this a few weeks ago. Same scenario, lens cap on and got the too much light message.I did a camera factory reset and I was able to calibrate the sensor from there and haven't had the issue happen again..

I'll try that today. thanks !

it worked !! many thanks
I was able to do the black shading and remove the ugly blue tint I had in the blacks at 1600 Iso

Good, Victor. I thought your original message mentioned the lens cap, but now I see it does not mention whether it was a lens cap or body cap but I must have been seeing things.


Sent from my iPhone using Tapatalk