- Posts: 1
- Joined: Mon Nov 11, 2019 5:55 am
- Real Name: SETH RAKERS
Mon Nov 11, 2019 7:26 am
Hi all,
Recently my camera bricked itself, and had to have its main PCB replaced. I have just received it back and connected it back to my rig and found that the HDMI out is not working. I tried 4 previous versions of firmware prior to 6.6. I have tried 3 HDMI cables (all of which i know are capable of transmitting the video feed). I have also tried various monitors. I have tried changing between RAW and Prores as well as performing a factory reset. I am powering the camera off a 14.8v/10.4Ah/150Wh Vmount Battery, along with the monitor. There is plenty of power for both units, and is a very common setup. The Monitor is a Feelword f7, powered through a DC cable that goes into the Vmount Plate, drawing power from the battery. The camera draws power throuhg Dtap, straight from the battery.
Any suggestions? Could this setup be the problem?
Thanks.
Recently my camera bricked itself, and had to have its main PCB replaced. I have just received it back and connected it back to my rig and found that the HDMI out is not working. I tried 4 previous versions of firmware prior to 6.6. I have tried 3 HDMI cables (all of which i know are capable of transmitting the video feed). I have also tried various monitors. I have tried changing between RAW and Prores as well as performing a factory reset. I am powering the camera off a 14.8v/10.4Ah/150Wh Vmount Battery, along with the monitor. There is plenty of power for both units, and is a very common setup. The Monitor is a Feelword f7, powered through a DC cable that goes into the Vmount Plate, drawing power from the battery. The camera draws power throuhg Dtap, straight from the battery.
Any suggestions? Could this setup be the problem?
Thanks.