DeckLink Studio 2 and BMCC

The place for questions about shooting with Blackmagic Cameras.
  • Author
  • Message
Offline

mihl

  • Posts: 3
  • Joined: Sat Aug 10, 2013 6:26 pm

DeckLink Studio 2 and BMCC

PostSat Aug 10, 2013 6:45 pm

Hi there,

I recently purchased a couple of BMCC's to take over from my "old" Panasonic's. I use a DeckLink Studio 2 to get an SDI-signal into my PC. I am however not able to get the SDI-signal from any of my BMCC's through the Studio2 card.

I think I have tried all possible permutations of the settings available. I would like to run with following settings:

Format: ProRes
Dynamic Range: Video
Frame Rate: 25 fps

WHat should the settings be on the DeckLink to get an image through?
Offline

mihl

  • Posts: 3
  • Joined: Sat Aug 10, 2013 6:26 pm

Re: DeckLink Studio 2 and BMCC

PostSun Aug 11, 2013 1:28 pm

I found the solution. It turns out that I needed to check 1080psf in the settings to make it work. All is now well.

Return to Cinematography

Who is online

Users browsing this forum: Craig Seeman, Gary film, Johannes Hoffmann, pnguyen720, Rich Camp, youlikeny and 23 guests