DeckLink Studio 2 and BMCC

Hi there,

I recently purchased a couple of BMCC's to take over from my "old" Panasonic's. I use a DeckLink Studio 2 to get an SDI-signal into my PC. I am however not able to get the SDI-signal from any of my BMCC's through the Studio2 card.

I think I have tried all possible permutations of the settings available. I would like to run with following settings:

Format: ProRes
Dynamic Range: Video
Frame Rate: 25 fps

WHat should the settings be on the DeckLink to get an image through?

I found the solution. It turns out that I needed to check 1080psf in the settings to make it work. All is now well.