- Posts: 390
- Joined: Fri Jan 15, 2016 5:09 pm
There is no switch, the DTap gets its power from the camera, you can power the camera with the mains plug, then check the voltage on the DTap, and/or on the little plug the plate connects to to make sure the return 12VDC is being sent from the camera. If so, then it is the battery plate. Otherwise, it could be the camera. In either case, I would contact BM Support office in your region.
You can also power the VA from the EVF power plug (4-pin XLR on the front side of the camera. I would check to make sure this plug is also outputting 12VDC.
Cheers