2 Tech Questions on Ursa Mini Pro 4.6
Posted: Wed Nov 15, 2017 9:39 pm
I have recently purchased an Ursa Mini Pro 4.6K and have run into a couple of questions.
1) If shooting Cinema DNG, does the White Balance setting matter? I mean does it just adjust the viewing device or does it actually; change the data being recorded?
2) I am trying to attach a Flanders field monitor via SDI. I get an image if it's plugged into the front (viewfinder) SDI out, but not on the rear SDI out. The monitor is set for 1080P 23.97 as is the camera, but I get a "no signal" message when connected to the rear SDI out.
1) If shooting Cinema DNG, does the White Balance setting matter? I mean does it just adjust the viewing device or does it actually; change the data being recorded?
2) I am trying to attach a Flanders field monitor via SDI. I get an image if it's plugged into the front (viewfinder) SDI out, but not on the rear SDI out. The monitor is set for 1080P 23.97 as is the camera, but I get a "no signal" message when connected to the rear SDI out.