Feature request: noise page on Tangent Wave

Hi,
I love my Tangent Wave and see no reason for upgrading to a Element set.
However, I wish there was a page dedicated to noise reduction controls. I hate adjusting these with the mouse.
Anybody else on the same boat?
Cheers,
Bernardo

You can just forget about it. There was no improvements to the Wave since, i think, version 8 or 9. None of the new functions are mapped to the Wave controls (except for the HSL qualifier changes), and Blackmagic just ignores all of the requests about Wave mapping.

You can just forget about it. There was no improvements to the Wave since, i think, version 8 or 9. None of the new functions are mapped to the Wave controls (except for the HSL qualifier changes), and Blackmagic just ignores all of the requests about Wave mapping.

As you said, they changed the HSL qualifier pages!
Don't be so negative

MidiTwister + Bome could get you there

I'd like to see more NR mapping for the Tangent Elements, too.

MidiTwister + Bome could get you there

I already have a custom setup with controller mate and a launch pad, but it has only buttons. I didn't know about Midi Fighter Twister. Thank you for the info. I will try it!

i have a macro fired from XKeys that opens the NR page, sets NR/better/2/20/20/unlinked

then i have luma and chroma values mapped to MidiTwister knobs

not a good as haveing all functions mapped, but much faster than mousing the whole lot, that's a typical starating point for me