Desktop Video problem

Hi I upgraded desktop video to 10.9.7 but when i go in Desktop video setup it says that No Desktop Video device detected please check blablabla...
but if I open Davinci Studio 14.1 my card is there and can use it for monitoring video?
Resolved the problem going back to version 10.9.3
now can see the Intensity pro 4K in Davinci and Desktop video setup it mst be a problem in 10.9.7 drivers.

Hello, same problem, I receive message "No desktop video device detected" when I open Desktop Video Setup 10.9.7
Nevertheless device H264 Pro Recorder is recognize and work well with Blackmagic Media Express.

I try with Desktop Video Setup 10.9.3 and 10.9.5 but then Blackmagic Media Express does not work anymore (device not recognize)

Any help please? Thank You

I'm having the same issue. I'm running OSX 10.11.6 with Decklink Extreme 3D - playback works ok in Premiere* and Resolve but Desktop Video isn't working with it (and nor is FCP7 FWIW).

* Actually I was getting some audio drift in Premiere but put it down to an issue my end. Perhaps that's actually not the case and these are just very flaky drivers as things seemed fine with the previous drivers.

* Actually I was getting some audio drift in Premiere but put it down to an issue my end. Perhaps that's actually not the case and these are just very flaky drivers as things seemed fine with the previous drivers.

There appear to be sync problems in Resolve 14.1 as well, with the decklink mini-monitor, and 10.9.7 (Windows).

[Peter Chamberlain]

Can you upgrade to 14.1.1 that was just released?

Can you upgrade to 14.1.1 that was just released?

Unfortunately, no change. Video is slow by about 5 frames on short cuts. Haven't tested longer ones. This is Prores Lt/wav out of the camera.