DaVinci Resolve OpenCL Problem

I used to install DaVinci Resolve on Intel's Skull Canyon NUC (1TB SSD/32GB RAM) until v14.0.1 without any problem. Now, with v14.1 (including v14.1.1 even) it installs but will no longer launch, explaining in a screen dialog incompatibility with OpenCL.

I too have a similar failure to start error on a new 7th gen NUC for Resolve.

Drivers, firmware and OS all up to date.

Did you try v14.2 ?

Yes.

I have the same issue with an AMD RX480. When I ran it from terminal, it reported that libcudart.so.7.5 was missing. This means that it looks for only an nVidia driver?

Jerry - 14.2.1 worked on my 7i7BNH NUC, under Win10

Haven't tried 14.3 yet.