Mon Jan 22, 2018 5:09 am
Hi John,
That worked perfectly! Thank you very much!
As an added note, I had to figure out, from your comments and my wee brain, that at the end of the clip, I had to put the cursor 10 frames in from the end, and then click the diamond next to the x/y line, and then go to the end of the clip and set x to zero.
So, if I understood it correctly:
With clip selected, and viewing the Inspector:
Cursor at beginning of clip, with x at zero, click diamond next to x/y line.
Cursor in 10 frames (for example), don't click diamond - just set x to value, e.g. -165.
Move cursor to end of clip, come back 10 frames to the left, click diamond.
Move cursor to end of clip, set x to zero.
Is this explanation / operation in the manual? If so, is it under a specific heading?
i.e. what would you call this operation?
Thanks again!!!
Peter
Windows 10-64-Pro
Dell Precision 7760 w/ i7 processor, 64 Gigs of Ram