- Posts: 1
- Joined: Mon Apr 09, 2018 5:32 pm
- Real Name: James Goolsby
Mon Apr 09, 2018 5:40 pm
Hello,
I was wondering if anyone else had this problem and how to correct it:
I am following the lessons in "The Definitive Guide". In lesson one I added the still photo of the furnace. Part of the lesson is to activate the Dynamic Zoom function, which I did. Once activated, however, I can see the start and stop boxes for adjusting, but the photo itself is just a gray box... I can't actually see anything. I can still adjust the boxes, and once I exit the photo comes back and the zoom works fine. But because I am essentially blind while working, it is difficult to get my end point lined up properly, and I have to go in several times to make small adjustments.
I am hoping this is just a setting or something that I need to correct.
Any suggestions would be much appreciated. It is quite frustrating. Thanks.
I was wondering if anyone else had this problem and how to correct it:
I am following the lessons in "The Definitive Guide". In lesson one I added the still photo of the furnace. Part of the lesson is to activate the Dynamic Zoom function, which I did. Once activated, however, I can see the start and stop boxes for adjusting, but the photo itself is just a gray box... I can't actually see anything. I can still adjust the boxes, and once I exit the photo comes back and the zoom works fine. But because I am essentially blind while working, it is difficult to get my end point lined up properly, and I have to go in several times to make small adjustments.
I am hoping this is just a setting or something that I need to correct.
Any suggestions would be much appreciated. It is quite frustrating. Thanks.