Not sure if I should post here or if I should make a new thread about it, but is the fusion tab just completely unreliable?
I'm comping CG 32 bit EXR sequences in fusion, was hoping to keep all comps in the edit this way. But when I go to the colour page it's all black.
Also when doing any motion graphics, simple titles etc. I get frames dropping out, even on render....
I have to go back to fusion stand alone because I just can't afford time lost on buggy software.
Am I doing something wrong or is everyone else having the same thoughts?
Here is my process that has gone wrong today:
For my CG comps I've been dragging my render passes into the media browser
I can't drag my exr sequences into the timeline so I create a solid colour and convert to compound clip
then go into the fusion tab and swap the solid colour media in with my CG beauty pass and proceed to comp with all of the render elements. All seems fine.
I move to the colour tab and begin the colouring process. All looks fine until I scrub the timeline. The screen just goes black!!! Comp gone....
Then go back to the edit page, the scene shows up on a few frames if I'm lucky.
The issue with motion graphics is that random frames just go black....
See screen shots below...
- fusion tab.JPG (205.15 KiB) Viewed 3604 times
- Edit tab.JPG (125.65 KiB) Viewed 3604 times