- Posts: 1
- Joined: Wed Feb 07, 2024 9:24 pm
- Real Name: Matt Casamassina
What you're describing is definitely not how you should work to get this kind of work done.
Without seeing screenshots or screencasts of what you're doing it is hard to tell what's causing this.
The most likely cause in this case is user error caused by lack of experience. I do this so often, it's hard to imagine ways for it to go wrong. But double-clicking a clip will load it in the source viewer. It will not send it to the Fusion page.
So let's start at the beginning:
If you right-click a clip and select 'open in Fusion page' doesn't it do that on your system?