- Posts: 46
- Joined: Tue Jan 20, 2015 10:40 am
Mon Feb 16, 2015 9:50 am
Hi,
i#m trying to set up the fusion render nodes – unfortunately with little success...
In the network preferences i can set the Render Master name (in the interactive version) but i can not set the IP address. after clicking save fusion resets to 0.0.0.0
In the Render Manager i can not set a node to Render Master (Error message: Failed)
When i try to configure a slave node, i get the same behaviour.
the strange thing is, that when i open a Render Manager it "sees" the slaves as online but it does NOT render anything.
Any ideas??
thx
Jörg-Mark
i#m trying to set up the fusion render nodes – unfortunately with little success...
In the network preferences i can set the Render Master name (in the interactive version) but i can not set the IP address. after clicking save fusion resets to 0.0.0.0
In the Render Manager i can not set a node to Render Master (Error message: Failed)
When i try to configure a slave node, i get the same behaviour.
the strange thing is, that when i open a Render Manager it "sees" the slaves as online but it does NOT render anything.
Any ideas??
thx
Jörg-Mark