Wed May 20, 2015 2:05 pm
Hey everyone,
I'm trying to figure out the following two steps for Fusion:
Preferably in a way that works both with Fusion 6, 7 and upcoming 8.
If you know dirty hacks let me know (woohoo!) or if there's an easy way forward that would be even better! If I can open command ports in Fusion and then hook into that from outside Fusion that's already a start.
I've tried using the eyeonScript.exe that comes with Fusion to connect to the app.
Though I'm only getting connections with Fusion 6 and not Fusion 7.
(Even though pinging with eyeonScript.exe also pings back if Fusion 7 is open!)
I'm trying to figure out the following two steps for Fusion:
- Being able to run a persistent thread, using
- Code: Select all
threading.Thread
- Being able to run a Fusion-command from another thread.
Preferably in a way that works both with Fusion 6, 7 and upcoming 8.
If you know dirty hacks let me know (woohoo!) or if there's an easy way forward that would be even better! If I can open command ports in Fusion and then hook into that from outside Fusion that's already a start.
I've tried using the eyeonScript.exe that comes with Fusion to connect to the app.
Though I'm only getting connections with Fusion 6 and not Fusion 7.
(Even though pinging with eyeonScript.exe also pings back if Fusion 7 is open!)