Fusion opens, I can see the work-space and then immediately closes. If I lower the screen resolution, then Fusion will open just fine without changing anything else.
I tried DR14 was considering purchasing with a purchase of Fusion 9 Studio. I wanted to try Fusion 9 first and cannot. It crashes during load. I have 4K multi monitor setup and am NOT scaling to 1080p.
Guess I have to reevaluate which software direction I am going to go. I am not spending money without a test run.
Windows 10 Pro Ryzen Threadripper 1950x 64GB 3200 Ram Two RX Vega 64 Two Samsung 960 Pro M.2 Three 50" 4K panels
I had tried that. I tried again after I read your post to no avail. It is very frustrating. I can't complain because it is a free copy, but considering I was going to purchase if it worked for me.....
Thanks for the reply Mike. Good to know this is not an issue and must be something else.
Fusion 9 will not load. It just shuts down before completing start up. I have tried everything I can think of. DR14 works perfectly. I am awfully disappointed I cannot get this to work.