- Posts: 2
- Joined: Fri Nov 24, 2017 12:37 pm
Fri Nov 24, 2017 12:44 pm
I'm trying out the pano_map to transform a 6x1 cube map to a altlong format. The documentation defines the order of the cube patches as: "ordered as Left, Right, Up, Down, Back, Front (+X, -X, +Y, -Y, +Z, -Z)".
Though the pano_map node does not following this convention. See screenshots of a conversion from example maps I got from the SolidAngle Arnold website.
I also tried some example cube maps from V-Ray and they show the same issue.
Joost
Though the pano_map node does not following this convention. See screenshots of a conversion from example maps I got from the SolidAngle Arnold website.
I also tried some example cube maps from V-Ray and they show the same issue.
Joost
- Attachments
-
- latlong_to_cube.jpg (806.81 KiB) Viewed 339 times
-
- cube_to_latlong.jpg (811.17 KiB) Viewed 339 times