Changing default settings for nodes

I've been learning Fusion 9 for some months now. What I notice is that I change the default settings over and over again to my preferred standard settings when I am building a comp.

So I was thinking: is there a way to change the default settings to my preferred values? Like, I'd like loaders to default to 16 bit float and have source color and gamma space active. Or have a LUT active for all viewers. Also, OpenCL makes all kinds of visual quirks here (and seems to be slower as I see on the forums), so I'd like to have it deactivated for most nodes, like color correction.

In short: can I change the default settings on a pre node basis?

Regards,
mgo

Aaaand ... found the right menu in the flow view literally a minute after posting.

Question still remains for viewers, though.

have you tried right clicking in the viewers too ?






...there's a save as defaults menu there as well...

have you tried right clicking in the viewers too ?


...there's a save as defaults menu there as well...

And there it is, thank You, sir