Page 1 of 1

Fusion RAW workflow

PostPosted: Fri Feb 02, 2018 1:32 pm
by Tom Janson
Hi All,

So I have a project I shot on the BMCC in RAW - I've edited it resolve, with no grading as yet. I wanted to add some camera shake with fusion, and then go back to resolve to start grading. After using fusion connect (.exr) the clip comes back into resolve with the colours wildly out of whack.

Is there an easy way to go from Resolve->Fusion->Resolve when editing RAW and preserving all the clip information? Any tips would be greatly appreciated.

PS I looked to see if there was a video dealing with this on Youtube - turns out 'Raw Fusion' was a 90s rapper and all I can find are videos with him and 2pac..