Blackmagic Forum

there is a fuse folder but when i put fuses in it nothing seems to happen.

Cheers

Ian

Fuses are not yet supported for Resolve 15. They should still register and be visible in the Choose Tool dialogue, but they may or may not actually do anything.

Fuses are supported. OpenCL Fuses don't work yet, true - but pure Lua Fuses in general work just fine.

Fusion Standalone does support OpenCL Fuses.

For easy installation and maintenance of Fuses on both Fusion Standalone and Fusion for Resolve (as well as scripts, templates,...) check our Reactor

I'll have to download a newer beta and test again. Last time, MultiMerge could be added to the Flow, and the control panel worked (though it was horrifyingly mangled by the new UI), but it didn't output an image. I haven't noticed anything in the release notes about improved Fuse support, but it may have been part of "general stability and performance improvements."

Pieter Van Houte wrote:Fuses are supported. OpenCL Fuses don't work yet, true - but pure Lua Fuses in general work just fine.

Fusion Standalone does support OpenCL Fuses.

For easy installation and maintenance of Fuses on both Fusion Standalone and Fusion for Resolve (as well as scripts, templates,...) check our Reactor

REACTOR? This is outrageous I cannot believe I am just learning about this now.

Thanks!

Bryan Ray wrote:I'll have to download a newer beta and test again. Last time, MultiMerge could be added to the Flow, and the control panel worked (though it was horrifyingly mangled by the new UI), but it didn't output an image. I haven't noticed anything in the release notes about improved Fuse support, but it may have been part of "general stability and performance improvements."

Woops - you're right. Definitely something wrong with MultiMerge... Seems like the image requests are borked. I've mainly tested things like time machine and suck less audio (unsurprisingly) and those are fine as modifiers - though I should probably double check on the new time machine Flow nodes...

EDIT - sent you something...

Ian Duncan wrote:

Pieter Van Houte wrote:Fuses are supported. OpenCL Fuses don't work yet, true - but pure Lua Fuses in general work just fine.

Fusion Standalone does support OpenCL Fuses.

For easy installation and maintenance of Fuses on both Fusion Standalone and Fusion for Resolve (as well as scripts, templates,...) check our Reactor

REACTOR? This is outrageous I cannot believe I am just learning about this now.

Thanks!

Enjoy the ride!