Tracking Paint in Fusion
Posted: Mon Dec 24, 2018 12:36 am
Hey there,
Recently started using Fusion along side the Color tab and I seem to be stuck on a pretty armature issue. For reference, the shot pans down.
So I have this dirty sign:
And I wanted to clean it up, pulled up the Paint tool and clone stamped it.
Great, I go to track it using the planar tracker, tracking works great, and I line it up as shown.
Great, then I hit play and... it falls apart. It seems to be tracking and moving the entire source into the paint, and not just the paint effect itself.
I can't post more than 3 images, so here is a link to the issue.
https://www.dropbox.com/s/6at0z0a7kr17fpi/4.jpg?dl=0
I'm sure I'm doing something super stupid, but can't figure it out.
Thanks.
Recently started using Fusion along side the Color tab and I seem to be stuck on a pretty armature issue. For reference, the shot pans down.
So I have this dirty sign:
And I wanted to clean it up, pulled up the Paint tool and clone stamped it.
Great, I go to track it using the planar tracker, tracking works great, and I line it up as shown.
Great, then I hit play and... it falls apart. It seems to be tracking and moving the entire source into the paint, and not just the paint effect itself.
I can't post more than 3 images, so here is a link to the issue.
https://www.dropbox.com/s/6at0z0a7kr17fpi/4.jpg?dl=0
I'm sure I'm doing something super stupid, but can't figure it out.
Thanks.