Page 1 of 1

DVIP kernel Positioner/Resize failed to run,error 2

PostPosted: Wed Jul 24, 2019 3:29 pm
by Enrico Perei
Hey guys,

during render (Fusion 16 Studio standalone) I get the following errors:
"DVIP kernel Positioner failed to run, error 2"
"DVIP kernel Resize failed to run, error 2"

The exr's and the QT render just fine but the log shows these errors appearing every frame or odd frame or so.

Any ideas what Fusion is unhappy about ?

I see them pop up occasionally during comp work as well.

cheers,
enrico

Re: DVIP kernel Positioner/Resize failed to run,error 2

PostPosted: Tue Aug 13, 2019 6:44 pm
by marklohde
I am having the same issue as well in Resolve 16

Re: DVIP kernel Positioner/Resize failed to run,error 2

PostPosted: Wed Aug 14, 2019 3:40 pm
by Bryan Ray
That indicates that something in the GPU code failed. Fusion falls back to CPU rendering (on most tools) when that happens, though, so you likely won't notice any problems in the render. It is probably just slower than it should be. If you can pare down your comp to the minimum number of nodes that produce the error, you should zip it up and post it here as a bug report.

Re: DVIP kernel Positioner/Resize failed to run,error 2

PostPosted: Wed Oct 02, 2019 9:56 pm
by DoubleTwistedCoil
Did somebody handled this problem? Short after i receive this massage Resolve crashes without any prompt.