Can't turn off Hue qualifier
Posted: Thu Nov 08, 2012 11:16 pm
I've noticed lately that every time I turn on a qualifier by dragging the picker across the viewer, the Hue gets "stuck on" permanently. A common example from my project:
Create a new node (serial or parallel, it doesn't matter)
Drag the picker across the viewer to enable qualifiers
Uncheck Hue and Saturation
Fiddle with Luma
After following these steps, I notice a lot of noise in the key. I found out that toggling Hue makes no difference on the image. Even when Hue is unchecked, it's still in effect. The workaround I'm using for now is to set the Hue width to 100%. Has anyone else noticed this problem?
EDIT: I just realized the problem also applies to Saturation and Luma qualifiers.
Create a new node (serial or parallel, it doesn't matter)
Drag the picker across the viewer to enable qualifiers
Uncheck Hue and Saturation
Fiddle with Luma
After following these steps, I notice a lot of noise in the key. I found out that toggling Hue makes no difference on the image. Even when Hue is unchecked, it's still in effect. The workaround I'm using for now is to set the Hue width to 100%. Has anyone else noticed this problem?
EDIT: I just realized the problem also applies to Saturation and Luma qualifiers.