Modifying EDID on Intensity Shuttle
Posted: Tue Nov 17, 2015 2:07 pmHi,
Is there a way to modify the EDID the Intensity Shuttle (USB3) sends out? It advertises 1080i, which causes laptops to happily choose that resolution even though my chain isn't too happy about it. (Of course, you can change the resolution on the laptop… except if you're plugging devices in and out all day, it's not so nice.)
Is there a way to tell it to e.g. cap the resolution list at 720p?
Optionally, publishing firmware enabling the fabled 1080p60 support would be nice, of course, but I'm not holding my breath… (Yes, I know if you have the Thunderbolt version, you can downgrade to a version that supports 1080p60. This is about USB3.)
Is there a way to modify the EDID the Intensity Shuttle (USB3) sends out? It advertises 1080i, which causes laptops to happily choose that resolution even though my chain isn't too happy about it. (Of course, you can change the resolution on the laptop… except if you're plugging devices in and out all day, it's not so nice.)
Is there a way to tell it to e.g. cap the resolution list at 720p?
Optionally, publishing firmware enabling the fabled 1080p60 support would be nice, of course, but I'm not holding my breath… (Yes, I know if you have the Thunderbolt version, you can downgrade to a version that supports 1080p60. This is about USB3.)