Decklink HDMI Audio Channel Order
Posted: Wed Sep 14, 2016 8:28 pm
Any feedback on this particular issue would be much appreciated. Thanks!
-Using Decklink Studio 4k
-Tested using both Avid and Resolve
-Using source media with 6 channels of audio in SMPTE order (L, R, C, Lfe, Ls, Rs)
-6 track timelines configured in both software for direct 6 channel output
-Connected the Decklink HDMI out to 2 different home theater receivers
-Configured the receivers for PCM audio
In all scenarios, both in Avid and Resolve, connected to either receiver….
CH 3 gets routed to the Sub and CH 4 gets routed to Center. This appears to be reversed. Is this correct? Is there a way to get the Decklink HDMI audio out routed as follows in SMPTE order:
CH1 – L
CH2 – R
CH3 – C
CH4 – Lfe
CH5 – Ls
CH6 - Rs
Also, I connected the SDI out of the Decklink to an AJA HI5 SDI-to-HDMI converter, then connected the HDMI out from the converter to each receiver and the audio channel order was correct: L, R, C, Lfe, Ls, Rs.
-Using Decklink Studio 4k
-Tested using both Avid and Resolve
-Using source media with 6 channels of audio in SMPTE order (L, R, C, Lfe, Ls, Rs)
-6 track timelines configured in both software for direct 6 channel output
-Connected the Decklink HDMI out to 2 different home theater receivers
-Configured the receivers for PCM audio
In all scenarios, both in Avid and Resolve, connected to either receiver….
CH 3 gets routed to the Sub and CH 4 gets routed to Center. This appears to be reversed. Is this correct? Is there a way to get the Decklink HDMI audio out routed as follows in SMPTE order:
CH1 – L
CH2 – R
CH3 – C
CH4 – Lfe
CH5 – Ls
CH6 - Rs
Also, I connected the SDI out of the Decklink to an AJA HI5 SDI-to-HDMI converter, then connected the HDMI out from the converter to each receiver and the audio channel order was correct: L, R, C, Lfe, Ls, Rs.