Change Labels Smartvideo HUB
Posted: Thu Jul 06, 2017 7:01 am
Hello guys,
I wanted to change the INputs and OUTputs labels of my SmartVideo Hub 20x20. So I connected USB cable between Smarttvideo Hub and a Mac Pro.
I openned the blackmagic application "VideoHub Setup". And it was written "Connect overt the network to configure the labels".
So I connected RJ45 cable between SmartVideo Hub and a Switch RJ45 (Mac is connected too).
But I have the same problem... I can't configure the labels ?
Can you help me please ?
Mac pro Yosemite 10.10.5
Smartvideo Hub Firmware version : 6.3
Thank you very much.
I wanted to change the INputs and OUTputs labels of my SmartVideo Hub 20x20. So I connected USB cable between Smarttvideo Hub and a Mac Pro.
I openned the blackmagic application "VideoHub Setup". And it was written "Connect overt the network to configure the labels".
So I connected RJ45 cable between SmartVideo Hub and a Switch RJ45 (Mac is connected too).
But I have the same problem... I can't configure the labels ?
Can you help me please ?
Mac pro Yosemite 10.10.5
Smartvideo Hub Firmware version : 6.3
Thank you very much.