Blackmagic Forum

I'd like to output individual clips for editorial as well as a single H.264 file with window burn for screening. Is that possible with Resolve v9rc1 in a single output pass?

It seems like you must decide between individual source clips and single clip near the top of the delivery page before you can add outputs. Scratch would handle this as separate output nodes, not sure if this is possible with the way Resolve's delivery page is structured.

What you're asking for is done by configuring a "job" and adding it to the "queue".

One for all the clips as separate files.
The second for the H264 with burn in.

When you're ready, hit "Start render" in the bottom of the queue.

Yes, I know I can queue them up, just wasn't sure I could do what I needed to do with a single job (multiple outputs).

It seems like it is almost a possibility since it looks like you can add/remove window burn and change the file type, you just can't change whether the output file(s) will be a single file (target) or multiple files (source).