Mon Jun 03, 2019 12:04 am
OK...had my Hyperdeck Studio Mini recording a feed from ATEM Studio HD interface which had 2 cameras plugged into it.
Signal was showing up on the Hyperdeck screen....no probs.
I hit the record button, the display said it was recording, and the red light above SD card 1 was flashing.
After recording for 2 hours (it was a conference) they broke for lunch, so I went into playback mode to make sure it recorded. Yup....it recorded.
The 2nd half of the conference started, so I exited out of playback mode, and hit the record button again.
The display said it was recording....but I noticed the red light above the SD Card 1 slot was not on, or flashing.
After this section was over, I hit the stop button.
I hit record again....same thing happened...Screen had the Red Record Dot on it, telling me it was recording, but no flashing red LED light above the SD card slots.
I get back to the studio, only to find that only the first part of the conference was recorded.....when the red LED light was flashing above the SD Card slot.
Does anyone know why this would have happened?????