Settings of Desktop Video

Hi Guys,

I have a problem setting the SDI-Interfaces of my "Blackmagic Decklink Duo 2" on Linux without GUI.

I want to set the SDI-Interfaces to non key/fill-mode and use every interface for its own on my Blackmagic Decklink Duo 2. Normally I would use Desktop Video to configure the interfaces but without GUI i cant use it.
So my question is, is there any config-data or registry-entry where the configuration of the SDI-interfaces is safed? Or maybe another way to configure it without GUI on Linux?

Thanks for helping me!

regards,

Norman Krüger

I'm not sure that it's possible to run the Desktop Video setup utility as a command line application (without a GUI), but it is possible to configure the connector mapping for the card through the DeckLink SDK. This will require a bit of programming though.

There are a few more details in this thread:
viewtopic.php?f=4&t=70862#p404361

Hi Dave,

Thanks fpr this quick reply! This looks also what i was searching for!

Regards,

Norman