Vectorscope: Why am I not seeing HIG/MID/LOW options?

I can't seem to figure out why the Vectorscope on my installation of R16.1b3 does not give me the options to see the STD/HIG/MID/LOW ranges? When I click on the Vectorscope options, none of those options are available:



This is happening on my dual-monitor setup at work. Oddly, on my Resolve system at home, which is running on a single Ultrawide display, this issue does not occur.

Probably gpu scopes are not enabled. You probably can’t select cie scopes either.

Ah yes, that was it! I must have disabled that, since I mostly use Scopebox for external scopes.

Thanks Tom.

Probably gpu scopes are not enabled. You probably can’t select cie scopes either.

Thanks for sharing, this just solved that same problem for me.