Inspector value drag glitch when reaching edge of screen
Posted: Wed Aug 07, 2019 2:11 am
DR16 Studio Beta 7 on Windows 10.
This has been an issue in DR15 too.
When you click and drag on a value in the inspector panel, if your mouaw reaches the edge of the display while you are dragging (ie if you are dragging the value to the right), the value jumps up dramatically.
eg dragging position:
Value starts at 0
Start dragging to the right
Value is at say 150
Hit the edge of screen > Value jumps to 1500
This makes it very difficult when trying to fitness positioning/cropping etc and has been the absolute worst bug trying to conform sequences with lots of photos / repos required.
Can provide further details if needed
This has been an issue in DR15 too.
When you click and drag on a value in the inspector panel, if your mouaw reaches the edge of the display while you are dragging (ie if you are dragging the value to the right), the value jumps up dramatically.
eg dragging position:
Value starts at 0
Start dragging to the right
Value is at say 150
Hit the edge of screen > Value jumps to 1500
This makes it very difficult when trying to fitness positioning/cropping etc and has been the absolute worst bug trying to conform sequences with lots of photos / repos required.
Can provide further details if needed