- Posts: 30221
- Joined: Fri Dec 23, 2016 1:47 am
Mon Aug 12, 2019 9:40 pm
I notice that when adding portions of a clip to a timeline using the Source Tape feature of the CUT page, those clips do end up with the appropriate red marks in the bin to show which portions are used, but they don't show the In/Out points (white vertical lines) that were set when those clips were added to the timeline.
Seems like they should.
Seems like they should.
My Biases:
You NEED training.
You NEED a desktop.
You NEED a calibrated (non-computer) display.
You NEED training.
You NEED a desktop.
You NEED a calibrated (non-computer) display.