- Posts: 22
- Joined: Wed Aug 22, 2012 6:27 pm
The firmware can be updated via the USB port on the back of the SmartView unit.
Download the utility from the download section of our website, install it on your computer and connect the SmartView to the computer via USB. When you run the utility it should prompt you to upgrade the firmware.
I believe at this time the only way to get the border colors to work is via the 9 pin tally port on the back (there is a silkscreen on the back that describes the pinout).
As an FYI we are currently at version 1.2 of the SmartView software.