- Posts: 165
- Joined: Thu Sep 27, 2012 1:35 pm
- Location: The Netherlands
Fri Aug 09, 2013 3:07 pm
How irritating can it be. When i playback a recording on my HyperdeckPro, the timecode indicated in it's screen, is perfectly followed by a multicam logger software is use.
As soon as i put the HyperdeckPro in record (a new Timecode begins) my software doesn't respond in anyway.
And the software is to be used as a switch logger while multi cam RECORDINGS are in session.
To know, i have hooked up the TC output from the HyperdeckPr into the audio input of a Mac Mini. In the settings of the Softron MulticamLogger, the settings are set to audio TLC and as i mentioned, it works, so now doubt about that, but only in PlayBack mode of the HyperdeckPro.
Is it a setting issue? Am i missing something? Or is it the wonderful world of BlackMagic again?
HELP!!!!!
As soon as i put the HyperdeckPro in record (a new Timecode begins) my software doesn't respond in anyway.
And the software is to be used as a switch logger while multi cam RECORDINGS are in session.
To know, i have hooked up the TC output from the HyperdeckPr into the audio input of a Mac Mini. In the settings of the Softron MulticamLogger, the settings are set to audio TLC and as i mentioned, it works, so now doubt about that, but only in PlayBack mode of the HyperdeckPro.
Is it a setting issue? Am i missing something? Or is it the wonderful world of BlackMagic again?
HELP!!!!!
Qmedia.nu
Lijnbaan 16
1969 NE Heemskerk
The Netherlands
Lijnbaan 16
1969 NE Heemskerk
The Netherlands