Connecting a sound mixer to ATEM Pro

Hello everyone,
I have a few questions for my live stream. I work for a church and we are thinking about buying a ATEM mini pro. I want to connect my sound board mixer to the Switcher. Is there anyway to do that? The reason behind doing it that way is so that I can run the audio and video out of the switcher into boxcast equipment. Currently I have a presonus studio live 16.4.2


Sent from my iPhone using Tapatalk

You can take a stereo mix from the mixer either the house mix or a separate aux (monitor) mix and go out analog and go into the ATEM through the 3.5 connector. On my Yamaha I use a aux mix so I can create a separate mix for video and have XLR to 3.5 cables.

Hi,

Is there a certain type of mixer that would be needed for compatibility, for example analog or digital or is would any mixer with two XLR outputs work?


Also, is this the type of XLR to 3.5 headphone that you would need? Thanks!

Hosa HMX-010Y Pro Stereo Breakout Cable - 3.5mm TRS Male to Dual XLR Male

Any mixer should work. You are taking an analog output via XLR, Usually outputs are male so you would need a female XLR to 3.5 cable.

Any mixer should work. You are taking an analog output via XLR, Usually outputs are male so you would need a female XLR to 3.5 cable.

I’m using a dual xlr to 3.5mm input Y type cable So stereo to audio input 1

Many thanks! So whether it's an analog or digital mixer isn't important in this case?

It is not.

You can take a stereo mix from the mixer either the house mix or a separate aux (monitor) mix and go out analog and go into the ATEM through the 3.5 connector. On my Yamaha I use a aux mix so I can create a separate mix for video and have XLR to 3.5 cables.

I am also trying to connect in this way from a Behringer x32. Could you post a link to the cable you purchased? Did you not use any kind of passive transformer?