ATEM to Premiere Issues

So my ATEM TVS is set to 1080 59.94i
But when I record in Native, it is recorded at 29.97
And then I pull it into Adobe Premiere and it comes in at 14.98
What in the world is happening that my frame rate keeps getting cut in half. If I upload the 29.97 file straight to vimeo it plays back just fine...but this is making edits impossible.

Thanks

You can set the framerate via the media properties in premiere. It's under interpret footage iirc


Sent from my iPhone using Tapatalk

I'm running into this exact same issue. When I import the video recorded from Media Express from the ATEM recording into Premiere, the audio plays fine but the video is slowed down and plays at a framerate of 14.98.

I tried changing the framerate in "Interpret footage" to 29.97, but then the video plays at around the right speed (with issues and dropped frames) and the audio is sped up at 2x speed.

I can open this video file in Quicktime or other programs and the video and audio play correctly.

Is there a setting in Adobe that is causing this to happen? Or is this a problem with the settings from when it was recorded?

I have the same setup as the initial poster:
ATEM TVS and Media Express are set to 1080 59.94i
Media Express in the Preferences is set to "Native (Progressive)" and Capture File Format is "H.264 MP4"
When pulled into Adobe Premiere it comes in at 14.98 framerate

Where am I going wrong? I have done this plenty of times in the past under what should be the same setup and haven't had this issue.

Any ideas how to fix it so I can edit in Adobe Premiere?

I am having the same issue? I can't even transcode the footage to work with it.

Was there a solution, is there a codecs download for it to work with Premiere?

Thanks

With MediaExpress, I always capture in 1080i, using the MJPEG codec. Files import fine into Premiere.