- Posts: 6
- Joined: Thu Aug 30, 2012 1:05 am
You would need two separate control surfaces to operate each 1 M/E independently. That's the biggest drawback of this approach.
You can achieve this on 1 computer by opening the control software twice and assigning a unique IP to each 1 M/E then pointing the software at the IP in the setup menu. Or you could use any combination of control surfaces and/or computers to control them.
Plus with 2 x 1 M/E's you effectively have a 15 input switcher (not 16) since you'll use 1 input on your downstream switcher to get the feed from your upstream.