2M/E Control Surface Travel Case

Hey awesome forum,

Anyone have any good suggestions for a case to transport my ATEM 2M/E Control surface in? Ideally something with wheels and a handle, or at least something we can use to both protect the unit and easily move it to different venues.

Thanks,

Benjamin

We are using PELI case .. I think 1560 model ... http://www.peli.com/en/maletas-medianas ... -1560.html

i can look at work tommorow .. We use old Echolab model .. I hope it have same dimensions ..

I doubt about the 1560.

1560 = about 50 cm long. The 2ME control panel is more than 100 cm's right?

Ahh .. 2me is the bigger one sorry .. we have small model ...

Wasn't the correct case, but it did get me poking on the site, and I eventually found this:
http://www.bhphotovideo.com/c/product/4 ... stId487055

I think it will fit with just a touch of room to spare on the edges for foam. A bit deeper than I would like, but everything else looks pretty darned close.

We have other purchases to make first, but once we get this I'll report back to the forum on how well it works.

Thanks,

Benjamin

we have a pelicase 1780 and it's fine!

Nicolas