- Posts: 4
- Joined: Fri Nov 10, 2017 2:21 pm
Fri Nov 10, 2017 2:30 pm
Hello Everyone, I'm starting this as a new topic because everything I could find in the forum is several years old.
I have recently started to use a couple of the hyperdeck studio mini's for production but the face plate controls are not very good for fine control, so I started with an old sony Edit controller and it worked great but I was looking for creating more cue points then it allowed. so I moved onto the DNF ST300 SSM-T VTR slomo controller. it has been great works well allows up to 100 cue points for each of the 4 decks. the only problem I'm having is stopping the records. while playing the stop function works well. on the other edit controller i was using the stop function worked as it should. so I'm trying to figure out what might be the issue with the DNF controller not stopping they are both RS422. Has anyone else run into this problem and did you find a solution?
the Controller is the
ST300 SSM-T
ST300-S-NS-T V3.0
the hyper deck minis are on the latest firmware
thanks Everyone
I have recently started to use a couple of the hyperdeck studio mini's for production but the face plate controls are not very good for fine control, so I started with an old sony Edit controller and it worked great but I was looking for creating more cue points then it allowed. so I moved onto the DNF ST300 SSM-T VTR slomo controller. it has been great works well allows up to 100 cue points for each of the 4 decks. the only problem I'm having is stopping the records. while playing the stop function works well. on the other edit controller i was using the stop function worked as it should. so I'm trying to figure out what might be the issue with the DNF controller not stopping they are both RS422. Has anyone else run into this problem and did you find a solution?
the Controller is the
ST300 SSM-T
ST300-S-NS-T V3.0
the hyper deck minis are on the latest firmware
thanks Everyone