Blackmagic Forum

How to mix SDI channel 3 audio with ATEM Switchers?I have to mix the channel 3 audio to program audio .becaseu the voice of arrator in channel 3 audio .If ATEM Switcher can't do this work.How can i do this?

You can't do this with your ATEM. The ATEM only supports Audio on channel 1+2 right now.

You need a deembedder or a Teranex to do this for you.


Deembedder:
You would deembed the SDI channel 3 and feed it back into the ATEM or your audio-mixer.

With the Teranex you would input the signal and remap SDI channel 3 to channel 1 or 2. You would then feed the output of the Teranex back into the ATEM. And voila - Audio on channel 1 or 2.

Cheers

Robert

A Decimator MD-HX can also remap audio channels. Cheapest audio remapper for $295

And also always good to have arround when you running an Atem setup.. For just that 1 source that does not work out of the box with your Atem.

Another vote for the MD-HX for re-mapping audio channels

I'll echo the use of the MD-HX we have several used to tame video sources, out in the wild
but I didn't know it could re-map audio. thanks...
Today im happy, I learnt something else new

Didn't know that too.

Seems to be a very versatile little unit

Cheers


Robert